Zanussi VCH2004R Instructions pour l'utilisation et l'entretien - Page 16
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisation et l'entretien pour {nom_de_la_catégorie} Zanussi VCH2004R. Zanussi VCH2004R 20 pages. Built-in ceramic hob
Également pour Zanussi VCH2004R : Instructions pour l'utilisation et l'entretien (20 pages), Instructions pour l'utilisation et l'entretien (20 pages)
Imprimer la page
Fitting the hob
Insert the hob into the recess cut
'oot making sure that the control
panel is on the right hand side.
Once the hob is in position press
firmly around the edges of the hob
to compress the foam (located on
the underside edges of the hob)
onto the kitchen worktop to create
a seal.
Clamping brackets are located on
the underside of the hob, one in
each corner. To secure the hob
align the clamp across the base of
the hob.and underside edge of the
kitchen worktop. Do this by
sliding the bracket backwards and
forwards around the fixing screws.
Tighten the clamps into position
by means of the fixing screws,
- through the clamp and into the
base of the hob.
However if the setting provided by
the clamping brackets ıs not
correct then the kitchen worktop
should be fitted with a suitable
filler piece where the worktop 1s
not deep enough to facilitate
fitting the clamp.
Conversely, if the kitchen worktop
is deeper than the body of the hob,
the worktop must be cut away
around the area where the fixing
clamps will be located, rather than
attempting to modify the clamp.
Warning
DO NOT OVERTIGHTEN
THE
CLAMPING BRACKETS,
THEY MERELY ACT AS A
STABILIZER AS THE WEIGHT
OF THE HOB IS SUPPORTED
BY THE WORKTOP.
OVERTIGHTENING
MAY
RESULT IN DISTORION OF
THE HOB BASE.
Having completed the installation,
turn the electricity supply back on
at the mains, and also the switch
supply to the hob.