Zanussi ZEI6240FBA Manuel de l'utilisateur - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZEI6240FBA. Zanussi ZEI6240FBA 16 pages. Product manaul
Imprimer la page
Problem
comes on.
and a number come on.
comes on
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ce-
ramic (it is in the corner of the glass surface)
and an error message that comes on.
Installation
Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, record
the information below from the rating plate. The
rating plate is on the bottom of the appliance
casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you as-
semble the appliance into correct built-in
www.zanussi.com
Possible cause
No cookware is on the cooking
zone.
The cookware is incorrect.
The diameter of the bottom of the
cookware is too small for the
cooking zone.
There is an error in the appliance.
There is an error in the appliance,
because a cookware boils dry.
The protection against become
too hot for the cooking zone oper-
ates. The Automatic Switch Off
operates.
Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instruc-
tions about the customer service and condi-
tions of guarantee are in the guarantee booklet.
units and work surfaces that align to the
standards.
Connection cable
• Use the correct mains cable of type H05BB-
F Tmax 90°C (or higher) for a single phase or
two phase connection.
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C or
higher). Speak to your local Service Centre.
To attach the seal.
• Clean the worktop in the area of the cut out
section.
• Bond the seal stripe supplied on the lower
edge of the appliance along the outer edge
Remedy
Put cookware on the cooking
zone.
Use the correct cookware.
Move cookware to a smaller cook-
ing zone.
Disconnect the appliance from the
electrical supply for some time.
Disconnect the fuse from the elec-
trical system of the house. Con-
nect it again. If
comes on
again, speak to the service centre.
Deactivate the appliance. Remove
the hot cookware. After, approxi-
mately 30 seconds activate the
cooking zone again.
go out of the display, residual heat
indicator can stay. Let the cook-
ware become sufficiently cool and
check it with the section Cook-
ware for the induction cooking
zone.
should
9