Zanussi ZEV8646XBA Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZEV8646XBA. Zanussi ZEV8646XBA 48 pages.
Également pour Zanussi ZEV8646XBA : Manuel de l'utilisateur (12 pages), Manuel de l'utilisateur (44 pages)
Imprimer la page
Problem
You cannot activate the outer
ring.
There is a dark area on the
multiple zone.
The sensor fields become hot.
comes on.
comes on.
and a number come on.
E6 comes on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes on.
Installation
WARNING!
Refer to Safety chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
www.zanussi.com
Possible cause
You decreased the heat setting
to
.
It is normal that there is a dark
area on the multiple zone.
The cookware is too large or you
put it too near to the controls.
Automatic Switch Off operates.
The Child Safety Device or the
Lock function operates.
There is an error in the hob.
The second phase of the power
supply is missing.
Make sure, you operated the hob correctly. If
not the servicing by a service technician or
dealer will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee are
in the guarantee booklet.
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
Connection cable
• The hob is supplied with a connection cable.
Remedy
Start from
and only increase
the heat setting.
Activate the inner ring first.
Put large cookware on the rear
zones if possible.
Deactivate the hob and activate it
again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some time.
Disconnect the fuse from the
electrical system of the house.
Connect it again. If
again, speak to an Authorised
Service Centre.
Check if the hob is correctly con-
nected to the electrical supply.
Remove the fuse, wait one mi-
nute, and insert the fuse again.
comes on
11