Zanussi ZGG 6420 Livret d'instructions - Page 8

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZGG 6420. Zanussi ZGG 6420 16 pages.

Imprimer la page

Important safety requirements

This hob must be installed in accordance with the Gas

Safety (Installation and Use) Regulations (Current

Edition) and the IEE Wiring Regulations (Current

Edition).

Detailed recommendations are contained in the

following British Standards Codes Of Practice: B.S.

6172/ B.S. 5440, Part 2 and B.S. 6891 Current Editions.

For appliances installed in the Republic of Ireland please

refer to NSAI- Domestic Gas Installation I.S. 813

Current Editions and the ETCI Rules for Electrical

Installations.

Provision for Ventilation

The hob should not be installed in a bed sitting room

with a volume of less than 20 m

room of volume less than 5 m

area of 110 cm

is required. If it is installed in a room of

volume between 5 m

and 10 m

area of 50 cm

is required, while if the volume exceeds

11 m

no air vent is required.

However, if the room has a door which opens directly

to the outside no air vent is required even if the volume

is between 5 m

and 11 m

If there are other fuel burning appliances in the same

room, B.S. 5440 Part 2 Current Edition, should be

consulted to determine the requisite air vent

requirements.

FITTING THE GAS HOB

WITHOUT A COOKER HOOD ABOVE

700 mm

400 mm

. If it is installed in a

an air vent of effective

400 mm

FO 0812

For appliances installed in the Republic of Ireland

please refer to the NSAI- Domestic Gas Installation I.S.

813 Current Editions Table Four.

Location

The hob may be located in a kitchen, a kitchen/diner or

bed sitting room, but not in a bathroom, shower room

or garage.

Before making the cut out in the worktop ensure that

the edges of the hob that are to be near either a side or

rear wall have a minimum distance of 55 mm. between

the edge of the hob and the wall.

The minimum distance combustible material can be

fitted above the hob is 400 mm. If it is fitted below 400

mm. a space of 50 mm. must be allowed from the edges

of the hob.

The minimum distance combustible material can be

fitted directly above the hob is 700 mm. A minimum

distance of 100 mm. must be left between the side

edges of the hob and any adjacent cabinets or walls.

For appliances installed in the Republic of Ireland please

refer to NSAI- Domestic Gas Installation I.S 813 Current

Edition Section 7- Permitted Locations of Appliance.

FITTING THE GAS HOB

WITH A COOKER HOOD ABOVE

650 mm

400 mm

FO 0813