Zanussi ZGM 782 Livret d'instructions - Page 9

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZGM 782. Zanussi ZGM 782 20 pages.

Installation

IMPORTANT: This hob must be installed by

qualified personnel to the relevant British

Standards.

Any gas installation must be carried out by a

registered CORGI installer.

The manufacturer will not accept liability, should

the above instructions or any of the other safety

instructions incorporated in this book be ignored.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to

remove any protective materials, which were put

on in the factory.

On the end of the shaft, which includes the G 1/2"

threaded elbow, adjustment is fixed so that the washer

is fitted between the components as shown in the

diagram. Screw the parts together without using

excessive force.

Gas Connection

Connection to the gas supply should be with either rigid

or semi-rigid pipe, i.e. steel or copper.

The connection should be suitable for connecting to R

1/2" (1/2 BSP male thread). When the final connection

has been made, it is essential that a thorough leak test

is carried out on the hob and installation.

Ensure that the main connection pipe does not exert

any strain on the hob.

Cut Out Size

The dimensions of the cut-out are given in the diagram.

FO 0264

A) End of shaft with nut

B) Washer

C) Elbow

It is important to install the elbow correctly, with

the shoulder on the end of the thread, fitted to the

hob connecting pipe.

Failure to ensure the correct assembly will cause

leakage of gas.

Rectangular cut-out size for hob

FO 2038

FO 0814