Zanussi ZGO63414 Manuel de l'utilisateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZGO63414. Zanussi ZGO63414 16 pages. 58 cm, 4 zones
Également pour Zanussi ZGO63414 : Manuel de l'utilisateur (40 pages), Manuel de l'utilisateur (48 pages), Manuel (44 pages), Manuel de l'utilisateur (40 pages)
Imprimer la page
A
B
A) End of shaft with nut
B) Washer
C) Elbow
D) Rubber pipe holder for liquid gas
Warning! It is important to install the
elbow correctly. Make sure that the
shoulder is on the end of the thread. Then install
it on the hob connecting pipe.
Incorrect assembly may cause a gas leakage.
Liquid gas
Use the rubber pipe holder for liquid gas. Al-
ways engage the gasket. Then continue with the
gas connection.
The flexible pipe is prepared for apply when:
– it can not get hot more than room tempera-
ture, higher than 30°C;
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting edges or
corners;
– it can be easily examined in order to make
sure its condition.
The control of preservation of the flexible pipe
consists in checking that:
– it does not show cracks, cuts, marks of burn-
ings on the two ends and on its full length;
10
C
– the material is not hardened, but shows its
correct elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
If one or more defects are visible, do not repair
the pipe, but replace it.
Important! When installation is complete,
make sure that the seal of each pipe fitting is
B
correct. Use a soapy solution, not a flame!
Adjustment of minimum level
D
To adjust the minimum level of the burners:
1. Light the burner.
2. Turn the knob on the minimum position.
3. Remove the knob.
4. With a thin screwdriver, adjust the by-pass
screw position.
A) The by-pass screw
Warning! Make sure the flame does not
go out when you quickly turn the knob from
the maximum position to the minimum position.
Electrical connection
• Make sure that the rated voltage and type of
power on the rating plate agree with the volt-
age and the power of the local power supply.
• This appliance is supplied with a mains cable
and a plug.
• Always use a correctly installed shockproof
socket.
• Make sure that there is an access to the
mains plug after the installation.
• Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
• There is a risk of fire when the appliance is in
connection with an extension cable, an
adapter or a multiple connection. Make sure
A
www.zanussi.com