Zanussi ZGS 645 Manuel d'utilisation - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Zanussi ZGS 645. Zanussi ZGS 645 21 pages.
Également pour Zanussi ZGS 645 : Manuel de l'utilisateur (40 pages)
Imprimer la page
Installation
The following instructions about
"
installation and maintenance must be
carried out by qualified personnel in
compliance with the regulation in force.
The appliance must be electrically
" " " " "
disconnected before all interventions. If
any electric supply to the appliance is
required to carry out the work, ensure all
the necessary precautions are followed.
The side walls of the unit in which the hob
" " " " "
is going to be installed, must not exceed
the height of the working top.
Avoid installing the appliance in the
" " " " "
proximity of inflammable materials (e.g.
curtains, tea towels etc.).
THE MANUFACTURER WILL NOT ACCEPT
LIABILITY, SHOULD ANY OF THE OTHER
SAFETY INSTRUCTIONS INCORPORATED
IN THIS BOOKLET OR THE REGULATION IN
FORCE BE IGNORED.
Gas connection
Choose fixed connections or use a flexible pipe
instainless steel in compliance with the
regulation in force. If using flexible metallic
pipes, be careful they do not come in contact
with mobile parts or they are not squeezed. Use
the same attention when the hob is combinated
with an oven.
IMPORTANT - To ensure a correct operation,
a savingof energy and the long life of the
appliance, the voltage pressure of the appliance
must correspond to the recommended values.
The adjustable connection is fixed to the
comprehensive ramp by means of a threaded
nut G 1/2". Interpose the sealing between the
components as shown in Fig. 5. Screw the parts
without forcing, adjust the connection in the
required direction and tighten everything.
Connection using flexible nonmetal
pipes
When the connection can be easily inspected
in its full extent, there is the chance to use a
flexible pipe according to the rules in force. The
flexible pipe must be tightly fixed using clamps
according to the rules in force.
Liquid gas: use the rubber pipe holder «D»
(Fig. 5). Always insert the gasket «B». Then
proceed with the gas connection. The flexible
pipe should be made ready for use in such a
way that:
- nowhere it can reach overtemperature, other
than room temperature, higher than 30°C; if
the flexible pipe, to reach the cock, must run
behind the range, it must be installed as
shown in picture;
- it is no longer than 1500 mm;
- it shows no throttles;
- it is not subject to traction or torsion;
- it doesn't get in touch with cutting edges or
corners;
-it can be easily inspected in order to check its
condition.
The control of preservation of the flexible pipe
consistsin checking that:
- it doesn't show cracks, cuts, marks of
burnings bothon the end parts and on its full
extent;
- the material is not hardened, but shows its
normal elasticity;
- the fastening clamps are not rusted;
- expiry term is not due.
13