Zanussi ZKT 623 LX Instructions d'utilisation et d'installation - Page 19
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Zanussi ZKT 623 LX. Zanussi ZKT 623 LX 23 pages. Elektric ceramic glass hob
Imprimer la page
With regard to the protection against overheating
of surrounding furniture surfaces this appliance
corresponds to type Y. This appliance or the built--
in cupboard for the appliance respectively may be
located with the rear wall and one side wall to wha-
tever high walls or furniture respectively and with
the other side to another appliance or furniture of
the same height as this appliance.
Hob installation
Cut out the worktop with the cut--out size as sta-
D
ted. The toleranced sizes must not be exceeded..
Saw exactly at the marking line. Recommenda-
tion: Mark the cut--out with a steel needle.Cover--
glue the line in order to avoid splintering of the
coating when cutting.
Clean the worktop in the cut--out section
D
With tiled worktops the grooves within the contact
D
area of the cooking area must completely be filled
up with groove material.
Then fasten the catch springs with screws in the
D
cut--out at the marked position. The distortion of
the springs serves as a stop on the worktop.
With natural, artificial stone, or ceramic plates the
D
springs can be glued in with special adhesive
(synthetic resin, two--component adhesive, etc.)
The cooking area is entered from the top into the
D
cut--out section, centered and firmly pressed on
until the springs will catch.
Check the seal in the supporting frame for perfect
D
seating and gapless support. Please do not apply
further silicone sealing matter as this will compli-
cate the removal of the hob if servicing is neces-
sary.
R5
sealing
worktop
39
1
2
frame
ceramic glass plate
snap--in clamp