Zanussi ZKT663 Manuel d'installation et d'utilisation - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Zanussi ZKT663. Zanussi ZKT663 30 pages. Ceramic glass hob
Également pour Zanussi ZKT663 : Manuel d'installation et d'utilisation (20 pages)
Imprimer la page
Timer
There are two ways to use the timer:
– as a safety cut-out function. Set a cooking period
for a cooking zone, and after this time has elapsed
the cooking zone will automatically switch itself off.
This function can be used for more than one cook-
ing zone simultaneously.
– as a countdown timer without a cut-out function
("egg timer"), whereby an acoustic signal can be
heard after the set period of time has elapsed.
3
The countdown timer cannot be used if a
cooking zone is switched on.
Safety cut-out
The cooking zone(s) for which you want to use the
safety cut-out function must be switched on.
1. Using the timer sensor panel
zone for which the safety cut-out is to be set.
By touching the timer sensor panel
active cooking zone is selected in a clockwise direc-
tion, and the corresponding control lamp will flash
rapidly. Hereby the (e.g.) left rear control lamp corre-
sponds to the left rear cooking zone. 00 will appear
in the timer display.
The next active cooking zone is selected by touching
the timer sensor panel again
2. While the control lamp is flashing rapidly, use the
or
timersetting sensor panels to set the de-
sired period of time for this cooking zone up until
the point where it automatically switches itself off
(e.g. 15 minutes).
The safety cut-out function will be activated after
several minutes
The control lamp will now flash more slowly and the
remaining cooking time will be shown in the display
as it elapses. If the safety cut-out function has been
set for more than one cooking zone, the time dis-
played will be that for the cooking zone with the
shortest period of cooking time remaining. The con-
trol lamps for the other cooking zones for which the
safety cut-out function has been set will illuminate.
To display the remaining cooking time for any of
these cooking zones, it must be selected using the
timer sensor panel
, and the corresponding control
lamp will then flash rapidly.
To reset the remaining cooking time the desired
cooking zone must be selected using the timer sen-
sor panel
. The corresponding control lamp will
then flash more rapidly. The settings are reset using
the
or
timer setting sensor panels.
, select the cooking
once the first
.
15