Zanussi ZBB24431SV Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZBB24431SV. Zanussi ZBB24431SV 17 pages.
Également pour Zanussi ZBB24431SV : Manuel de l'utilisateur (17 pages)

Zanussi ZBB24431SV Manuel de l'utilisateur
WARNING! Do not touch frozen
goods with wet hands. Hands can
freeze to the goods.
3. Leave the door open.
In order to speed up the defrosting process,
place a pot of warm water in the freezer
compartment. In addition, remove pieces of ice
that break away before defrosting is complete.
4. When defrosting is completed, dry the interior
thoroughly.
5. Switch on the appliance.
After three hours reload the previously removed
food into the freezer compartment.

PERIODS OF NON-OPERATION

When the appliance is not in use for long periods,
take the following precautions:

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
The lamp does not work.
The compressor operates con-
tinually.
8
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost (if necessary) and clean the appliance
and all accessories.
4. Clean the appliance and all accessories.
5. Leave the door/doors open to prevent
unpleasant smells.
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrectly.
Many food products to be fro-
zen were put in at the same
time.
The room temperature is too
high.
WARNING! If you want to keep the
appliance switched on, ask somebody
to check it once in a while to prevent
the food inside from spoiling in case of
a power failure.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.