Zanussi ZBF22456S1 Manuel de l'utilisateur - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZBF22456S1. Zanussi ZBF22456S1 17 pages.

Imprimer la page

•

A - green and yellow: Earth

•

C - brown: Live

•

D - blue: Neutral

As the colours of the wires in the mains lead of this

appliance may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows:

1. Connect the wire coloured green and yellow to

the terminal marked either with the letter "E" or

by the earth symbol

yellow.

2. Connect the wire coloured blue to the terminal

either marked with the letter "N" or coloured

black.

3. Connect the wire coloured brown to the

terminal either marked with the "L" or coloured

red.

4. Check that no cut, or stray strands of wire is

present and the cord clamp (E) is secure over

the outer sheath.

Make sure the electricity supply voltage is the

same as that indicated on the appliance rating

plate.

5. Switch on the appliance.

The appliance is supplied with a 13 amp fuse (B).

In the event of having to change the fuse in the plug

supplied, a 13 amp ASTA approved (BS 1362)

fuse must be used.

WARNING! A cut off plug inserted

into a 13 amp socket is a serious

safety (shock) hazard. Ensure that it is

disposed of safely.

VENTILATION REQUIREMENTS

The airflow behind the appliance must be sufficient.

or coloured green and

5 cm

min. 200cm

min.

200cm

DOOR REVERSIBILITY

1. Loosen and remove the upper pin and spacer.

2. Remove the door.

3. Remove the lower spacer.

4. Loosen the lower pin with a key.

5. Tighten the lower pin on the opposite side.

6. Install the lower spacer.

7. Install the door.

8. Tighten the spacer and the upper pin.

Do a final check to make sure that:

•

All screws are tightened.

•

The magnetic seal adheres to the

cabinet.

•

The door opens and closes

correctly.

If the ambient temperature is cold (i.e.

in Winter), the gasket may not fit

perfectly to the cabinet. In that case,

wait for the natural fitting of the gasket.

In case you do not want to carry out

the above mentioned operations,

contact the nearest Authorised

Service Centre. The Authorised

Service specialist will carry out the

reversibility of the doors at your cost.