Zanussi ZFC330WA Manuel de l'utilisateur - Page 36
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZFC330WA. Zanussi ZFC330WA 40 pages. Chest freezer
Également pour Zanussi ZFC330WA : Manuel de l'utilisateur (25 pages)
Imprimer la page
Problem
The appliance is noisy
The compressor operates con-
tinually
There is too much frost and ice
The lid doesn't close complete-
ly
The lid is difficult to open
It is too warm in the freezer
36
Possible cause
The appliance is not supported prop-
erly
The temperature is not set correctly.
The lid has been opened too frequently Do not leave the lid open longer than
The lid is not closed properly
Large quantities of food to be frozen
were put in at the same time
Food placed in the appliance was too
warm
The temperature of the room that con-
tains the appliance is too high for ef-
ficient operation
Products are not wrapped properly
The lid is not shut properly or do not
close tightly
The temperature is not set correctly.
The water drainage plug is not cor-
rectly positioned
There is excessive frost
The lid gaskets are dirty or sticky
Food packages are blocking the lid
The lid gaskets are dirty or sticky
The valve is blocked
The temperature is not set correctly.
The lid does not close tightly or it is
not shut properly
Before freezing the appliance was not
precooled sufficiently
Large quantities of food to be frozen
were put in at the same time
Food placed in the appliance was too
warm
Solution
Check if the appliance stands stable
(all the four feet should be on the floor)
Set a warmer temperature
necessary
Check if the lid closes well and the gas-
kets are undamaged and clean
Wait some hours and then check the
temperature again
Allow food to cool to room tempera-
ture before storing
Try to reduce the temperature in the
room where the appliance stands
Wrap the products better
Check if the lid closes well and the gas-
kets are undamaged and clean
Set a warmer temperature
Position the water drainage plug in the
correct way
Eliminate excess frost
Clean the lid gaskets
Arrange the packages in the right way,
see the sticker in the appliance
Clean the lid gaskets
Check the valve
Set a lower temperature
Check if the lid closes well and the gas-
ket is undamaged and clean
Pre-cool the appliance for enough time
Wait some hours and then check the
temperature again. Next time insert
smaller quantities of food to be frozen
at any one time.
Allow food to cool to room tempera-
ture before storing.