Zanussi ZFT11112WV Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZFT11112WV. Zanussi ZFT11112WV 17 pages.

Imprimer la page
Problem
Power indicator light is flash-
ing.
The compressor operates con-
tinually.
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Temperature cannot be set.
Door is misaligned or interferes
with ventilation grill.
Possible cause
An error has occurred in meas-
uring the temperature.
The appliance is not working
properly.
The temperature in the appli-
ance is too high.
Temperature is set incorrectly.
Many food products to be fro-
zen were put in at the same
time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The QuickFreeze function is
switched on.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The QuickFreeze function is
switched on.
The appliance is not levelled.
Solution
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "QuickFreeze func-
tion".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
Switch off QuickFreeze man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "Quick-
Freeze function"
Refer to "Levelling".
9