Alean SM-HWDS-Z11 Manuel de l'utilisateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Alean SM-HWDS-Z11. Alean SM-HWDS-Z11 7 pages. Intelligent laser intrustion detector
Imprimer la page1st digit
Normal working
0000 means normal working condition
condition
Debugging
Display C
alignment model
Debugging
alignment
Display L
model(Visible light)
1st digit
Normal working
Display 0
condition
Debugging alignment
Display C
mode
Trigger condition
Display E
setting
Response time
Display F
setting
Bypass Laser Beam
Display H
setting
2nd digit
01~12 indicates the current beam.If 01 is
displayed,it means that the current aligning
beam is the 1st beam,and so on.
01~12 indicates the current beam.If 01 is
displayed,it means that the current aligning
beam is the 1st beam,and so on.
2nd digit
3rd digit
1~12 indicates the current beam. If 1 is
displayed, the beam with the lowest signal
is 1 or the current 1 beam is triggered.
01-12 indicates the current beam. If 01 is
displayed, it means that the current
aligning beam is the first beam, and so on
001~012 indicate the current trigger conditions. If 001 is
displayed, it means that the current trigger condition is to block 1
beam to trigger the alarm, and so on. If the current display is 003
when setting, it means that the current trigger condition is to
block 3 beams to trigger the alarm.
050, 100, 300, and 700 indicate that the alarm response time is
50ms, 100ms, 300ms and 700ms. If 50 is displayed, the trigger
response time is currently set to 50ms, and so on.
(1) 01~12: The current laser beam which need ON/OFF bypass.
After into programming, it will auto play from 01 beam to 12beams
till ex it.(2) Digit display of beam number blinking, means that
beam is bypass status.(3) Digit display of beam number keeping
lighting,means that beam is activated mode.(4) If need change
the laser beam status, just click the function button once when
auto playing the beams on the LED Digital display.
3rd digit
4th digit
Way of enter
Enter normal working mode when no
operation or ex it operation
Press the function adjustment button for
Display 0
more than 3 seconds to enter the
alignment mode
Press the function adjustment button for
more than 10 seconds to enter the
Display 0
alignment mode (Note: Visible light
aligner and invisible light aligner cannot
4th digit
0 ~ 9 indicates the
current beam signal
intensity, 9 is the
strongest signal, and
0 is the weakest
signal.
Way of ex it
Press again to ex it
when last beam is
displayed
Press again to ex it
when last beam is
displayed
Way of enter
Way of ex it
Enter normal working mode
when no operation or ex it
operation
Press the function
Press again to ex it
adjustment button for more
when last beam is
than 3 seconds to enter the
displayed
alignment mode
Press the function
Automatically save
adjustment button 2 times to
and ex it after 5
enter this mode
seconds without any
operation, return to
Press the function
normal working
adjustment button 3 times to
mode
enter this mode
Detector will auto
Keep pressing function
play from 01 beam to
button >10seconds, and then
the last beam and
into bypass mode.
then auto ex it.