Zanussi ZHC 955 Manuel du propriétaire - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Zanussi ZHC 955. Zanussi ZHC 955 16 pages. Zanussi owners manual ventilation hood zhc 955
Également pour Zanussi ZHC 955 : Instructions d'utilisation et d'installation (16 pages)

Imprimer la page

Wall unit mounting - Fig. 7-8-9

Disconnect the hood during electrical connection,

by turning the home mains switch off.

Remove the grease filter.

• Rest the motor unit on a flat surface and thread

the lower part of the hood onto it (1).

• Make all the electrical connections between the

two parts (2).

• Secure the two parts using 12 screws (3).

• Mark the wall with a centre line, this will aid the

fixing procedure (4), position the template so

that the mid line printed on the template

matches with the centre line previously marked,

the lower side of the template corresponds to

the lower side of the hood once installed (5).

• Drill two holes Ø 8mm and fix the support

bracket with two wall plugs and screws (6).

• Hang the hood (7) adjust its position (8-9) and

from the inside of the hood mark one point for

final fixing (10), remove the hood (11) and drill

an hole Ø 8mm (12), fit a wall plugs (13).

• Drill two holes Ø 8mm on the upper side close

to the ceilling (14), fit two wall plugs and fix the

chimney support with two screws (15).

• Hang the hood again (16).

• Fix it securely with a screw (17). To simplify

the installation operation remove the charcoal

filter frame.

• If the hood is used in the recirculation

function, fix the deflector F on the chimney

support G with four screws and fit an extraction

pipe (18 - not supplied) to connect deflector to

the outlet hole B of the hood.

In case the hood is to be used in exhausting

version, then the deflector must not be mounted

and fit an extraction pipe (18) to connect outlet

hole B of the hood to the outside.

• Make the electrical connection (19), but leave

the hood disconnected from the household

mains supply.

• Fix the chimney (20a) to the chimney support

(20b) slide downwards (21) and , from the

inside the of the hood (22).

Slide down the lower section on the proper housing

on top of the hood. Refit the grease filter.

Connect the hood to the household mains supply

and check that the hood works correctly.