Zanussi ZHC945 Livret d'instructions - Page 16

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZHC945. Zanussi ZHC945 21 pages.

Mounting the hood body

• Before attaching the hood body, tighten the two screws

Vr located on the hood body mounting points.

• Hook the hood body onto the screws 12a

• Fully tighten support screws 12a

• Adjust screws Vr to level the hood body.

Extraction (Ducted)

The cooker hood is more effective when installed in the

extraction mode (ducted to the outside).

Venting kits may be purchased through your retailer or DIY

store, and must be evacuated through an outside vent of

ø125 (5ins) or ø150mm (6ins).

The ducting used must be manufactured from fire

retardent material conforming to the relevant British

Standard or DIN 4102-B1.

When the cooker hood is ducted to the outside the

charcoal ﬁ lter must be removed.

Fitting the Ducting

• Fit the ø150mm (6ins) ducting to the spigot on top of

the hood body as illustrated.

• When using ø125mm (5ins) ducting ﬁ t item 9 and

10 on to the spigot on the top of the hood body as

illustrated.

• For the best performance use the shortest possible run of ducting and we recommend the use of rigid pipe in

preference to ﬂ exible hose as this will improve the ﬂ ow of air while reducing turbulence, which causes causes

noise and a loss of performance.

• If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler,

then its ﬂ ue must be be of the room sealed or balanced ﬂ ue type.

• If other types of ﬂ ue or appliances are ﬁ tted ensure that there is an adequate supply of air to the room.

• The cooker ducting when ﬁ tted in the evacuation mode must never be connected to central heating ﬂ ues,

radiators or water heaters.

• Put connection 15 into the connection support 7.3.

• Insert the connection extension pieces laterally 14.1

in connection 15.

• Make sure that the outlet of the extension pieces

14.1 is horizontally and vertically aligned with the

chimney outlets.

• Connect the air outlet connection 15 to the hood body

outlet using either a ﬂ exible or rigid pipe

120 mm, the choice of which is left to the installer.

• Ensure that the activated charcoal ﬁ lters have been

inserted.

INSTALLING THE COOKER HOOD

ø 150 or