Directed Directechs DB3 Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directed Directechs DB3. Directed Directechs DB3 20 pages. Smart key for 2013 toyota highlander
Également pour Directed Directechs DB3 : Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel (6 pages), Manuel d'installation (18 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (10 pages), Manuel d'installation (19 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (10 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (19 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (17 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages)

Imprimer la page
Directed Directechs DB3 Manuel d'installation

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
For
Convenience-Only
programming, see next section.
Ensure vehicle is in a safe location and cannot move forward during programming. For
1
vehicles equipped with a manual transmission, make sure the gearshift is in the neutral
position.
The harnesses must be connected in this exact order:
  1. Connect the 14-pin.
  2. Connect the 12-pin.
2
  3. Connect the 10-pin.
  4. Connect the 4-pin D2D cable (if being used).
When the LED turns ON solid red, proceed with the next step.
Press the Push-to-Start (PTS) button once (1) to turn the ignition ON.
If Tan & Tan/Black CAN wires are connected, the LED will flash orange then turn solid
-
3
green for 3 seconds then turn OFF.
-
If the Tan & Tan/Black CAN wires are not connected, the LED will flash orange up to 15
seconds, then flash green, orange, green and then turn off.
4
Press the PTS button once (1) more to turn the ignition OFF.
You have successfully completed the module programming sequence.
10
403.FORD18 1.09 2023 Ford E-Transit
©2023 Directed. All rights reserved.