Directed Directechs DB3 Manuel d'installation - Page 4

Imprimer la page

Directed Directechs DB3 Manuel d'installation

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

compatible

Vehicle Takeover

Firmware notes

Factory hood pin: In vehicles not equipped with a Factory Hood Pin, must permanently ground the vehicles N.C. OEM Hood Pin

input for successful operation. See Directechs for hood pin location.

Pit Stop: The vehicle pit stop/idle mode feature is not available in this firmware.

Remote Start Ready (RSR):

•RSR installations are not compatible with vehicles equipped with a manual transmission.

•RSR is a function that enables the interface module to remote start the vehicle completely on its own

Consequently, there is no need for an aftermarket or an OEM remote starter in order to start the vehicle from a distance.

The optional Plug & Play THFOD2 T-Harness is sold separately

The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.

SmartStart Compatible: SmartStart is equipped with D2D, which means it can be connected to an interface module and used in

Remote Start Ready (RSR) mode without the use of a remote starter. See "Module programming" for more information.

All T-Harness wires not listed in the diagram are not required for the installation.

All connectors are displayed from the wire side (unless specified otherwise).

Refer to the "Vehicle connections" following the installation diagram.

Conditions and Limitations

This installation enables the OEM remote starter and the remote start system will not work in the following conditions:

The ignition is on.

The alarm system is triggered.

The doors/hood are open.

The transmission is not in Park (P).

The vehicle battery voltage is too low.

The service engine light is on.

Note: Any stored DTC code errors will prevent vehicle from remote starting (no visual lights on dash).

RS Features: The following remote starter features can be configured via the information display:

Climate control

Heated seats/steering wheel

Runtime (for best results, program the remote starter runtime to match the OEM setting)

Remote Starter enable/disable

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin or if

not supported in data.

[2] Optional parking lights: They will flash when locked/unlocked, and stay ON during remote start runtime. They are only required for

visual confirmation in the event of a remote start failure.

403.FORD12 2.07 2022 Ford Transit

THFOD2

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation