Clarke REBEL 30 Instructions d'utilisation et d'entretien - Page 9
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke REBEL 30. Clarke REBEL 30 14 pages.
Imprimer la page
FAULT FINDING
PROBLEM
The compressor
Bad connections.
stops and will not
start again.
Blown fuse
Overload cutout
switch has tripped.
The compressor
Compressor head
does not reach
gasket blown or valve
the set pressure
broken.
and overheats
easily.
Compressor does
Air receiver charged
not start.
(see also item 1)
Air leaking from
Faulty non-return
the pressure switch
valve.
valvewhen the
compressor is not
running.
Air pressure from
The diaphragm within
the regulator will
the regulator body is
not adjust.
broken.
The compressor is
Compressor damaged
very noisy and
and needs overhaul.
makes a metallic
knocking sound.
PROBABLE CAUSE
Check the electrical
connections.
Clean and tighten as
necessary.
Renew/Replace fuse
Switch off and wait 5 minutes
before pressing the reset button.
Wait for compressor to cool
down, disassemble the head
and replace any broken
components.
Carefully clean all sealing
surfaces before reassembling.
If in doubt contact your
nearest dealer.
NOTE: It is also possible that
you are using more air than
the compressor is capable of
delivering.
Open drain cock to expel air.
Compressor should start again
when pressure reduces to
approx 95 psi.
First drain the receiver
completely of air. Remove the
valve end plug, carefully
clean the valve seat and the
gasket and reassemble. See Fig7.
Replace Regulator
Return the machine to your
nearest service agent.
10
REMEDY