Directed Directechs DB3 Manuel d'installation - Page 6

Imprimer la page

Directed Directechs DB3 Manuel d'installation

OEM remote starter information

If the vehicle has an active OEM remote starter it will program into convenience only (no immobilizer bypass). The reason for this is to allow

aftermarket security to be installed while keeping the factory remote starter active. If you wish for the interface to control the remote start sequence,

perform one of the following:

If the vehicle is equipped with a physical add-on Lexus/Toyota OEM Remote Starte

Some Lexus/Toyota vehicles may have an Add-On remote starter. If the OEM unit is installed, whether Active or Inactive, it MUST be permanently

disconnected, as both modules cannot coexist. Refer to 'Physical OEM remote start locations" in the chart below and always physically inspect

and disconnect any OEM remote starter before programming any Directed products.

If the Vehicle is Equipped with an OEM Remote Starter:

If the vehicle is equiped with an OEM RS, the module will detect it and won't complete the programming sequence in order to prevent OEM RS

to lose its programing. To complete the module programming you need to disconnect the OEM RS. refer to led diagnostic.

Physical OEM remote start locations:

Installation

Vehicle

Type

Lexus LX 570 2010-2015

Toyota Land Cruiser 2010-2015

403.TL3 4.12 2012 Lexus LS 460 (Smart Key)

OEM Remote Starter & Connectors Location

Behind Glove Box & Passenger Kick Panel