Directed Directechs DB3 Manuel d'installation - Page 11

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

For

Convenience-Only

programming, see next section.

This product should not be installed in any convertible vehicles, soft or hard top with a manual transmission. Installation in such vehicles may

pose certain risk and will not be supported.

Ensure vehicle is in a safe location and cannot move forward during programming.

The harnesses must be connected in this exact order:

Connect the 14-pin.

Connect the 12-pin.

Connect the 10-pin.

When the LED turns on solid red, proceed with the next step.

With only one key inside the vehicle, press the Push-to-Start (PTS) button twice (2x) to

turn the ignition on.

The LED will start to flash orange quickly, then green quickly.

Turn the ignition off by pressing the PTS button one time (1x).

Note: If 2 keys are present, the module will program but will not remote start.

Cycle the ignition on and off up to 10 times (10x) by pressing the PTS button twice (2x), then

once (1x) to shut the ignition off.

The LED will start flashing orange slowly.

Turn the ignition off, remove the module from the vehicle, and reconnect it to your

computer.

The website will automatically recognize that you are moving onto the second phase

of the programming sequence.

Click Submit Key2GO Request.

Once the configuration is completed, reconnect the module.

The LED turns on solid green for 3 seconds, then turns off.

You have successfully completed the module programming sequence.

403.CHRYSLER15 1.16 2021 Jeep Wrangler (Smart Key)