Directed Directechs DB3 Manuel d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directed Directechs DB3. Directed Directechs DB3 20 pages. Smart key for 2013 toyota highlander
Également pour Directed Directechs DB3 : Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel (6 pages), Manuel d'installation (18 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (10 pages), Manuel d'installation (19 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (10 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (19 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (17 pages), Manuel d'installation (18 pages)

Imprimer la page
Directed Directechs DB3 Manuel d'installation

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
Ensure vehicle is in a safe location and cannot move forward during programming. For
1
vehicles equipped with a manual transmission, make sure the gearshift is in the neutral
position.
The harnesses must be connected in this exact order:
  1. Connect the 14-pin.
  2. Connect the 12-pin.
2
  3. Connect the 10-pin.
  4. Connect the 4-pin D2D cable (if being used).
When the LED turns ON solid red, proceed with the next step.
Turn the key to ignition position.
3
The LED will start to flash green and orange.
Press Unlock on the factory key fob (if not available, press the programming button 5 times).
4
The LED turns ON solid orange for 3 seconds then shuts off.
5
Turn vehicle ignition OFF.
You have successfully completed the module programming sequence.
11
403.GM7 4.11 2005 Pontiac G6
©2023 Directed. All rights reserved.