Aleko Victoria Series Instructions pour l'installation et le manuel d'utilisation - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions pour l'installation et le manuel d'utilisation pour {nom_de_la_catégorie} Aleko Victoria Series. Aleko Victoria Series 12 pages. Sizes 6.5x5 8x6.5 10x8
Également pour Aleko Victoria Series : Manuel d'installation (20 pages), Manuel d'assemblage (14 pages), Manuel d'installation (17 pages)
Imprimer la page
Page 3
4. Installation of gear box: Combine left roller support (D-1)
D-1 D-3 D-4
with gear box (D-3) through bolt (D-4) M6x50, refer to
Diagram 1. Then install right roller support (E-1) and round
E-2 E-1
Diagram 1
shaft cover (E-2) together as in Diagram 2.
Diagram 2
5. Installing of arm shoulder: Assemble arm shoulder (H), bolt
G
H
M10x65 (G), washer and adjustable bolt M10x30 (I) together,
refer to Diagram 3.
I
Diagram 3
6. Torsion bar and arm shoulder assembly: Link torsion bar and arm shoulder, tighten arm
shoulder with bolt M10x65 (G) with socket head wrench. Set positions of arm shoulder for
both side against different awning sizes. (This step is already done by factory.)
7. Arm shoulder Assembly: Link both left (L-1) and right (L-2) arms with corresponding
arm shoulder through bolt M10x50 (K). (This step is already done by factory.)
Warning: Arms should be tied together during installation to avoid bouncing out and cause
injury.
K
L-1
L-2
8. Spread out both of the fabrics (M) and valance (O) and insert fabric liner (N). Push one
end of fabric with liner inserted into gauges on roller, then the other end through front bar.
(Attention: The fabric has two sides: front and back. The back side is with hem facing
downwards) See below image.