Aleko Victoria Series Manuel d'installation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Aleko Victoria Series. Aleko Victoria Series 17 pages. Sizes 6.5x5 8x6.5 10x8
Également pour Aleko Victoria Series : Manuel d'installation (20 pages), Instructions pour l'installation et le manuel d'utilisation (12 pages), Manuel d'assemblage (14 pages)

IMPORTANT: All bolt holes must be aligned vertically and horizontally to ensure

• •

that the awning hangs straight.

Double check alignment before drilling if you are not certain.

IMPORTANT: The diameter and depth of your mounting holes must be the same

• •

size as the expansion bolts.

STEP 3: Preparing For Mounting

1. Now that all of your holes are drilled, insert the expansion bolts.

2. It may be necessary to drive the bolts in with a wooden (or other non-metallic) mallet.

If a mallet is necessary for installation, we recommend placing the nut on the screw

(loosely) before hammering to avoid damaging the bolt threads.

3. Make sure that the bolts are firmly in place, yet let them stick out of the wall approximately 1 inch or less - enough

that the wall bracket can be installed onto them.

4. Firmly tighten the bolts with a 19mm hex key. It is best to use the hex key with a closed end rather than an open end

to avoid damaging the nut, should it slip.

Expansion bolt

Washer

1. Now that the bolts are securely in the wall, remove the nuts that are loosely

placed over the bolts.

2. Place a wall bracket onto one set of bolts. This should be an easy fit if the

bolt holes are properly aligned.

3. Once the wall bracket is resting on the bolts, place a washer over the bolt,

then secure it with a nut, as shown in the diagram.

brackets MUST sit firmly on the wall.

4. The

must tighten it more.

5. Repeat this step for each of the wall brackets. Once you do this, all wall

brackets will be securely in place.

Nut

Bolt

If there is any movement, you