Clarke Contractor CBS2 Manuel d'utilisation et d'entretien - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke Contractor CBS2. Clarke Contractor CBS2 17 pages.
Également pour Clarke Contractor CBS2 : Instructions d'utilisation et d'entretien (17 pages)
Imprimer la page
OPERATION
1. Connect the plug to the mains socket and switch on.
2. Hold the sander firmly with both hands
USING THE TRIGGER SWITCH
1. Squeeze the trigger, the belt
sander will start.
2. Release the trigger to stop the
belt sander.
3. If continuous operation is
required, squeeze the trigger, and
depress the lock-on button and
release the trigger.
4. To stop the belt sander, squeeze
the trigger to release the lock-on
button, then release the trigger.
USING THE SANDER
1. Make sure that there are no nails or other objects in the area to be sanded.
2. Let the sander reach full speed before applying it to the work surface.
3. Do not apply pressure to the sander during use. The weight of the sander
alone is sufficient for normal use.
4. Move the sander evenly over the work area. Do not allow the sander to
stay in one place for too long, this will give an uneven finish.
5. Replace worn sanding belts. The performance of your sander is
dependant on the quality of the sanding belts being used.
6. Remove the sander from the work area before releasing the trigger, (wait
until the belt has stopped moving before putting the sander down.
SANDING HINTS
1. Always use both hands to hold the sander and clamp the workpiece for
added stability and safety.
2. When sanding wood, always sand in the direction of the grain,
• Do not exert pressure on the sander.
• Regularly check the condition of the abrasive accessory and replace
when necessary.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9