California Air Tools 255C Manuel - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} California Air Tools 255C. California Air Tools 255C 7 pages. 2.5 gallon pressure pot
Imprimer la pageAssembly
Read the instructions carefully
Read instructions carefully before using this product.
This equipment can be used up to a maximum of 60 PSI.
This equipment has an air regulator, pressure gauge, safety valve and air hose connection.
The picture above illustrates the best set up and operation of this equipment.
Important Notes
This picture is only for the purpose of illustration. Air compressor "A", air filter "B", air hose and operator
safety equipment are all sold separately.
This product is subject to slight changes as to what is presented in this owner's manual. Without notice in
both changes in design and parts can occur in order to better increase the performance of the product.
Air Compressor
Use an air compressor that can produce at least 90 PSI.
1.
WARNING!
Ensure the air supply is clean and does not exceed 90psi while operating the tool.
Too high air pressure maybe dangerous causing damage or personal injury.
2. Drain the air compressor air tank daily. Water in the air line will damage the tool.
3. Clean air inlet air filter weekly.
4. The air hose should not be longer than 50ft.
The minimum hose diameter should be 1/4" I.D. and fittings must have the same inside dimensions.
5. Keep hose away from heat, oil and sharp edges. Check hose for wear and make certain that all
connections are secure.
Assembly Instructions
1. Connect the air supply hose to the air inlet fitting (#1) Industrial (1/4") Male on tank regulator.