Clarke 5060205 Manuel d'utilisation et d'entretien - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 5060205. Clarke 5060205 8 pages. Pressure test pump
Imprimer la page
GENERAL SAFETY RULES
WARNING: AS WITH ALL EQUIPMENT, THERE ARE CERTAIN HAZARDS
INVOLVED WITH THE USE AND OPERATION OF THIS PRODUCT. EXERCISING
CAUTION WILL REDUCE THE RISK OF PERSONAL INJURY.
1. ALWAYS thoroughly familiarise yourself with this product and its operation,
and follow all instructions in this manual.
2. ALWAYS ensure that the pump is properly positioned where necessary to
prevent it from moving during operation, and that the immediate area
surrounding the pump is kept clear.
3. ALWAYS use only replacement parts supplied by the manufacturer. The use
of non standard parts could be hazardous.
4. ALWAYS ensure that any residual pressure has been relieved before
performing any maintenance.
5. ALWAYS use only piping, hose and fittings rated equal to or greater than
the maximum PSI rating of the pump.
6. ALWAYS maintain the equipment in good /clean condition for the best/
safest performance.
7. ALWAYS wear eye protection when working with pressurised systems.
8. ALWAYS return any systems that has been sealed off for testing to their
original state before the system can be used again.
9. ALWAYS wash your hands thoroughly after handling used oil.
10. NEVER exceed the recommended testing pressure for any water heating
system or component within that system.
11. NEVER use this pressure tester for tasks it is not designed to perform.
12. NEVER use this product if it is damaged.
13. ALWAYS establish the correct testing pressure for the pipework/installation
to be tested before attempting to pressurise the system.
14. NEVER allow children to use this product.
15. NEVER attempt any repairs to this appliance.
16. NEVER throw away used oil with domestic refuse or flush down a sink or
drain. Collect any old oil in a leakproof container and take it to you local
waste disposal site.
17. If necessary, have the pump repaired by a qualified person using identical
replacement parts to ensure that the safety of the product is maintained.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4