Alemite 7818-F5 Manuel d'entretien - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Alemite 7818-F5. Alemite 7818-F5 16 pages. Pump hoist and power ram

Imprimer la page

SER 7818-F5

Installation and Operation

NOTE: Refer to Figures 2-A through 2-E

and Figure 3 for component identification on

the installation and operational procedures.

WARNING

Do not exceed the lowest pressure rating

of any component in the system.

Read each step of the instructions carefully. Make

sure a proper understanding is achieved before

proceeding.

Item

Part No.

No.

327247

Kit, Adapter

131402

Gasket

332469

Adapter, 1-3/4 " -20

330976

Adapter, 2" -16

Legend:

Part numbers left blank are not available separately

Figure 3 Follower Plate Pump Adapters

Revision (6-04)

1-800-548-1191-http://[email protected]

Description

Qty

Adapter Attachment to Pump

IMPORTANT: The adapter used is depen-

dent on the model of the pump. See Table 1.

Adapter Model 327247

1. Remove the original primer body from the pump.

2. Remove the nut that secures the primer plate to the

primer rod.

3. Remove the valve seat from the pump tube and discard

both aluminum gaskets.

4. Install and seat Gasket (b), the valve seat, and

additional Gasket (b) into the pump tube.

5. Secure the plate to the primer rod with the nut.

• Tighten the nut securely.

6. Screw Adapter (c) [with Loctite 222] into the pump

tube.

• Tighten the pump tube securely.

Adapter Model 330976

7. Screw Adapter (d) onto the pump tube [with

Loctite 222].

• Tighten the pump tube securely.

Pump Attachment to Hoist

8. Loosen Nuts (1) that secure Rod (2) to Bridge (5).

9. Remove the pipe plug from the top of the air motor.

10. Position the pump assembly onto Follower Plate

Assembly (29).

11. Thread the Rod (with thread sealant) into the pump's

air motor until it bottoms.

• Tighten the Rod securely.

12. Turn top Nut (1) to raise the pump assembly slightly

off the Follower Plate Assembly

13. Position Gasket (76) onto the Follower Plate.

• Make sure the holes are in alignment.

14. Install Screws (75) into the pump's adapter.

• This aids in aligning the pump with the Gasket and

Follower Plate Assembly.

15. Turn top Nut (1) to lower the pump assembly onto the

Gasket and Follower Plate.

IMPORTANT: Both Nuts are secured to the

hoist once the Follower Plate is attached.

Pump Hoist and Power Ram

Alemite Corporation