Clarke CVP1000 Instructions d'assemblage et d'entretien - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage et d'entretien pour {nom_de_la_catégorie} Clarke CVP1000. Clarke CVP1000 2 pages. Rotary vane pump
Imprimer la page
ASSEMBLY
COMPONENTS SUPPLIED
FITTING THE PUMP TO A DRUM
1. Assemble the pump using the handle, collar, spout and inlet tube supplied.
• The pump body is marked with IN for the inlet tube and with an arrow for the outlet tube.
• Use PTFE tape at all connections.
2. Fit the collar over the inlet tube before screwing the tube to the pump body.
3. Screw the collar into the threaded opening of the barrel.
4. Raise or lower the inlet tube so that it is just above the bottom of the drum when fitted. Set in position by tightening
the collar.
USING THE PUMP
1. Make sure all connections are secure and place a suitable container under the outlet tube.
2. Rotate the handle to draw fluid from the drum.
• The first time you use the pump, it may take several turns of the handle before liquid begins to flow.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLED