Alemite 7331 Manuel d'entretien - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Alemite 7331. Alemite 7331 6 pages. Shield for heavy-duty hose reel

Imprimer la page

SER 7331

Installation

NOTE : Refer to Figure 2 for component identi-

ﬁcation on the installation procedures.

WARNING

Read each step of the instructions carefully.

Make sure a proper understanding is achieved before

proceeding.

NOTE : The following is written for a multiple

reel installation unless otherwise noted.

Attachment of Mounting Plates ( 2 ) to metal fram-

ing channels or other suitable structure will vary.

Refer to Figure 4 for a typical installation.

The Mounting Plates can be installed with the

connecting hose openings on opposite sides. This

allows the distribution lines to route on both sides

of a bank.

IMPORTANT: Make sure to orient each Mounting

Plate so the connecting hose opening is in align-

ment with the distribution line.

1. Install Mounting Plates (2) to metal framing channels or

other suitable structure (mounting hardware not included).

• Do not tighten the hardware at this time

Mounting Plate

Figure 3 Reel Assembly Installation into Mounting Plate - Bottom View

Revision (9-98)

1-800-548-1191-http://[email protected]

2. Install Screws ( 3 ) and Nuts ( 4 ) that align the

Mounting Plates to each other.

• Tighten the Screws securely.

3. Tighten the mounting hardware securely.

4. Slide each reel assembly into the track slots of the

Mounting Plate. See Figure 3 .

5. Install each Clamp ( 6 ) to the Mounting Plate with

Bolts ( 7 ).

• Hold the reel assembly ﬁrmly against the stop

6. Check to ensure the reel assembly is secure to the

Mounting Plate.

7. Secure Strut ( a ) to the Mounting Plate and reel

assembly with Screws (3) and Nuts (4).

• Tighten the Screws securely.

8. Install Alignment Brackets (5) [observe THIS SIDE

UP] between each reel assembly with Screws (3)

and Nuts (4).

• Tighten the Screws securely.

9. Follow the procedures for assembling the hose reels

within Service Guide SER 7334-D.

• See the section entitled In the Shield.

Access hole

for connecting hose

Clamp

Bolt

Shield for Heavy-Duty Hose Reel

IMPORTANT: Make sure the reel assem-

bly seats squarely against the stop.

while tightening each Bolt.

NOTE : The following step is for a single

reel installation only.

Reel Assembly

NOTE: Sheave removed for clarity.

Alemite Corporation