Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION. Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION 16 pages. One-way fm automatic/manual transmission remote starter

2.
The parking lights will flash twice to confirm that the doors have been unlocked.

Remote Trunk Release

If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
button for 3 seconds on the remote transmitter. In addition, this will also disarm
the OEM style alarm.

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode:
1.
With the engine running, make sure to release the brake pedal and press the
button on the transmitter until the parking lights come ON.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
button to lock the doors, to arm the starter kill and to arm the OEM style
alarm.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode (page-5); at the last step, press
the system and leave the engine running.
Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of
the engine run time.
Note2: If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will enter Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.

Valet Mode

When the vehicle is in Valet Mode, the remote starter and alarm functionalities are disabled. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from
being remote-started accidentally.
Any of the following features will put your remote car starter into Valet Mode:
Ignition Valet: This feature allows you to put your system into Valet Mode by
using the ignition key.
Remote valet: This feature allows you to put your system into Valet Mode by
using the transmitter.
To put the system into Valet Mode
To put the system into Valet mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2.
The parking lights will flash three times.
3.
Turn the ignition OFF.
User guide
,
or
button to lock the doors, arm
P.7