Clarke 59231A Manuel de l'opérateur et liste des pièces - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur et liste des pièces pour {nom_de_la_catégorie} Clarke 59231A. Clarke 59231A 12 pages.
Imprimer la pageINTRODUCTION
The extractor tools are tools for cleaning the carpet. When
used with an extractor, the tools apply cleaning solution
to the carpet, and removes dirty solution and soil from
the carpet.
•
Use the 4" metal and 4" plastic hand tools to clean
stairs and small areas of carpet. These tools clean a
path 3-1/2 inches wide.
•
Use the 8" plastic wand and 12" metal wand to clean
edges of a room and larger areas of carpet. The 8"
wand cleans a path 8 inches wide. The 12" wand cleans
a path 12 inches wide.
•
The extractor has controls to start the pump for the
solution and the motor for the vacuum. The fl oor tool
has a control to release the solution.
How To Operate The 4" Hand Tools
NOTE:
Instructions for preparation and opera-
tion of your extractor are given with
the extractor.
CAUTION: Clarke will not be held liable for damage
to the carpet, or poor results because
of operator's lack of training.
To operate the 4" hand tools, follow this procedure:
1.
Connect the vacuum hose to the hose connector
on the extractor and to the end of the vacuum tube
on the fl oor tool.
2.
Connect the solution hose to the extractor and the
fl oor tool. To fasten the quick-disconnect, slide
the knurled collar on the female coupling away
from the opening. Push the male coupling into the
female coupling.
3.
The switch that activates the motor for the pump is
on the extractor. Put the switch in the "ON" posi-
tion.
4.
The switch that activates the motor for the vacuum
is on the extractor. Put the switch in the "ON" posi-
tion.
5.
Begin at the right-hand corner of the area to be
cleaned.
6.
Press the solution release lever. Pull the tool to-
ward you at a slow steady speed.
4 - FORM NO. 79042A
CLARKE Extractor Tools Operator's Manual