Clarke 7310000 Instructions d'utilisation et d'entretien - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 7310000. Clarke 7310000 4 pages. Floor cleaner

Imprimer la page

BEFORE USE

ATTACH THE FLOOR CLEANER TO THE PRESSURE WASHER

1. Slide the spigot end of the floor

cleaner accessory into the handle

assembly.

2. Push in firmly and twist 90° to lock

it into position.

APPLYING CHEMICALS AND CLEANING AGENTS

1. Ensure the trigger lock is in the locked position and the pressure washer is

switched OFF.

2. Remove the lid from the

detergent tank and fill with the

required amount of detergent.

• Only use detergents

recommended for use with

pressure washers, such as

CLARKE Traffic Film Remover

which is a powerful low

foaming agent for patio

cleaning etc.

3. When the tank is filled with detergent, replace the lid.

USING YOUR FLOOR CLEANER

1. Activate your pressure washer according to the instructions supplied with

the pressure washer.

2. Slowly move the floor cleaner over the surface being cleaned.

• Make sure you keep the floor cleaner parallel to the floor.

3. When cleaning the edge of the patio, do not allow the floor cleaner to tip

over the edge, as this may damage the floor cleaner if the rotating brush

strikes the edge on the patio.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]