Directed Electronics 3808A Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directed Electronics 3808A. Directed Electronics 3808A 18 pages. Auto-mate

Imprimer la page

Directed Electronics 3808A Manuel d'installation

RED/BLACK (+/-) DISARM DEFEAT INPUT

Connect to a wire that pulses (+) 12V OR ground when ALL doors unlock (usually the passenger door motor

or driver door unlock switch). Disarming will be defeated if this wire receives a pulse simultaneously with

the Disarm input. This is a polarity selectable input, (see features programming table for options).

[Required add-on security system connection]

RED (+) DISARM INPUT

Connect to a wire (usually the driver door motor) that pulses (+) 12V when the driver door unlocks using the

OEM remote to disarm the system. This wire triggers the Disarm command for the system.

[Required add-on security connection]

GREEN/BLACK (+/-) ARM DEFEAT INPUT

Connect to a wire that pulses (+) 12V OR ground when the doors lock (usually the driver door lock switch).

Arming will be defeated if this wire receives a pulse simultaneously with the Arm input. This is a polarity

selectable input, (see features programming table for options).

[Optional add-on security connection]

DARK GREEN (+) ARM INPUT

Connect to a wire (usually the driver door motor) that pulses (+) 12V when the doors lock. This wire triggers

the Arm command for the system.

[Required add-on security connection]

Light flash Polarity Setting

The internal fuse is used to determine the light flash output. In the (+) position, the on-board relay outputs (+)

12V on the WHITE wire. In the (-) position, the on-board relay will supply a (-) output. When wiring into a

multiplex circuit, you can replace the fuse with a resistor (paying attention to the polarity setting). (Refer to

diagram on White/ Black wire description).

Note: For parking light circuits that draw 10-amps or more, the internal jumper must be switched to a (-)

light flash output. P/N 8617 or a standard automotive SPDT relay must be used on the light flash output

wire.

Light Flash

Polarity Jumper Detail

Note: Replace fuse with speci ed resistor value

if connecting to multiplex light circuit

(paying special attention to polarity selection).

[Required connection for both configurations]

LIGHT FLASH POLARITY

(10A (MAXIMUM) FUSE JUMPER)