Alemite 3575-B Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Alemite 3575-B. Alemite 3575-B 8 pages. Oil control handle with mechanical meter

Imprimer la page

Mechanical Meter Oil Control Handle

Notice

Do not strike oil control handle

if it fails to operate. Refer to trouble-

shooting guide or return unit to nearest

authorized service center.

Before each use check all hoses for

signs of wear, leaks or loose fittings.

Tighten all fluid connections regularly

and replace weak or damaged hoses.

Before attempting any repairs or

maintenance of product disconnect air

supply from oil pump, release oil line

pressure by pressing lever on oil control

handle.

Assembly

Use Teflon tape (or suitable thread sealant)

when connecting the oil control handle to an

oil hose.

Outlet Nozzle

The outlet nozzle can be fitted either "in

line" (forward) or on the outlet port "pistol

style" located under the handle.

The long outlet tube should be used for the

"in line" option.

The short adaptor (44) should be used with

the outlet nozzle assembly (50) taken off the

long outlet tube when using the "pistol style"

option (see fig. 2).

Notice

Use threaded plug supplied to

seal outlet port not in use.

Outlet Nozzle Operation

When fluid flows through the handle the

outlet nozzle will automatically open. When

the fluid flow stops the outlet nozzle will auto-

matically shut.

Initial Release 10-15

Figure 2

Control meter showing three alternate

pistol-style configurations

Operation

To latch the handle first press the lever (40)

followed by push button (37). To release latch

simply press and release lever (40).

The top accumulative register will record

the total volume of oil passed through the me-

ter. The bottom register is a reset-able batch to-

tal, which can be reset by pressing the reset

button.

Maintenance

C a u t i o n

Do not perform maintenance with air

supply connected.

Do not perform maintenance with fluid

inside handle under pressure.

Failure to comply may result in minor or

moderate injury.

Inspect your oil control handle daily for any

signs of damage.

Replace any damaged parts or components as

required.

Control Handle

Disassembly

Use a clean bench to carry out maintenance.

1 Remove the oil hose from the control handle

inlet swivel (33).

2 Unscrew and remove swivel (33) washer

(32) and O-ring (31) from the control han-

dle inlet. Clean or replace the strainer (35)

and O-ring (34).

3 Slide off the handle sleeve (27).

4 Remove valve spring (30), valve seal as-

sembly (29) and plunger (28).

Alemite, LLC

SER 3575A