Directed Electronics XK01-AMDL Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directed Electronics XK01-AMDL. Directed Electronics XK01-AMDL 3 pages. American door lock interface & gm immobilizer override

Imprimer la page
1700G1
Description:
American Door Lock Interface & GM Immobilizer Override
Functions:
Lock/Unlock, Driver's Priority Unlock, Trunk/Hatch, Sliding Door Left & Right , OEM Security Alarm Arm/Disarm, Data to Analogue
Door Trigger Output (-)
IMPORTANT! Please read this installation guide thoroughly before installing the 1700G1. Use only a high quality digital multi-meter for testing. This product connects to the vehicle's low
voltage signal wire and improper installation or testing can result in damage to the vehicle. Never use a test light or logic probe to test wires in this vehicle!
10 PIN HARNESS
WIRE
VEHICLE
I/O
D2D
PIN
COLOR
TYPE
w2w
STATUS
1 to 4
Input
D2D
Brown
1
w2w
5 to 7
D2D
Input
w2w
1 to 5
Input
D2D
w2w
Green
2
D2D
Input
6 to 7
w2w
D2D
3
Blue
Input
All Types
w2w
Output
Violet/
All Types
4
D2D
White
w2w
All Types
5
Violet
Data
Type 4
Output
w2w
Pink/
Type 7
D2D
Input
6
White
w2w
1,2,3,5,6
N/C
N/C
Input
1 & 4
w2w
Input
Type 2
D2D
Pink
7
w2w
Input
Type 7
D2D
w2w
3,5 & 6
N/C
N/C
1, 4 & 5
D2D
Input
8
w2w
Orange
D2D
2,3,6 & 7
Input
w2w
9
All Types
Red
Input
D2D
w2w
All Types
D2D
Black
Input
10
w2w
LEGEND:
RCS = Remote Control System
AMERICAN DOOR LOCK INTERFACE
& GM IMMOBILIZER OVERRIDE XK01-AMDL
GM ONLY:
Override GM Passkey3 Transponder Immobilizer & Passlock 2 Immobilizer via data bus
D2D = Optional use of 4 Pin Data to Data (D2D) cable will replace the analogue wire (w2w) connection
(-)
Connect
/(+)
Location
SPECIFIC WIRE CONNECTION LOCATION
(-)
RCS
Ground When Running Output of Remote Starter
(-)
Ground When Running Output of Remote Starter
RCS
(-)
RCS
Lock Output wire
(-)
RCS
Lock Output wire
(-)
RCS
Unlock Output wire
(-)
RCS
Door Sense Trigger Input wire
On Board Diagnostic Connector (OBDII) PIN 2
Vehicle
(See Fig.2)
(-)
Vehicle
Connect to Vehicle's Brown Accessory Wire
(-)
RCS
AUX 2 Output
N/C
N/C
N/C
(+/-)
Connect to Domelight (2 Door Vehicle N/A)
Vehicle
(-)
AUX 1 Output
RCS
AUX 1 Output
(-)
RCS
N/C
N/C
N/C
(-)
RCS
Disarm Output
(-)
Trunk Release Output
RCS
(+)
Constant (+) 12 Volt Source
Vehicle
(-)
Vehicle
Chassis Ground
N/C = No Connection
ACTIVATION and/or FUNCTIONALITY
OEM Security Arm/ Disarm + Immobilizer Bypass + Defrost + Heated Seats at 32ºF (0ºC)
OEM Security Arm/Disarm + Defrost + Heated Seats at 32ºF (0ºC)
-Locks All Doors
-Window Roll-Up Feature: Activated with 2ND press of aftermarket remote
(See User Settings, MODE 5)
Locks All Doors
Unlocks All Doors (See User Setting, MODE1)
Detects Door status (Open/Close) via data bus:
then converts to an analogue output (-)
Data Commands from Module to Vehicle
Window Roll-Up (Relay Required, See Fig. 1)
1sec. (-) Pulse Left Sliding Door Open/Close
(See User Settings, MODE 3)
N/C
Domelight = Rear Door Detection
Opens Fuel Door
1 sec. (-) Pulse Right Sliding Door Open/Close
N/C
Connect if vehicle does not disarm upon remote start
Trunk Release
Power Source
Ground Source
N/A = Not Applicable W2W= analogue wire to wire
Installation
Manual
(1\3 Pages)
(See User Settings, MODE 2)
(See User Settings, MODE 2)
D2D= data 2 data