Clarke Fusion 20 Manuel de l'opérateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Clarke Fusion 20. Clarke Fusion 20 20 pages.

HOW TO PREPARE THE MACHINE FOR OPERATION

How To Install The Pad

To install or remove pad on the machine, follow this pro-

cedure (see steps 1 - 6 in Figure 6):

Turn the key switch off "O".

Put the machine in the position shown (2) to accss

the pad retainer.

Go to the front of the machine. While holding the

pad retainer with one hand, rotate the pad and pad

driver counter clockwise to loosen the pad retainer.

Remove the old pad and install a new one, being

careful to center it on the outside diameter of the

pad driver. NOTE: Vibration could occur if you

center the hole in the pad to the opening for

the pad retainer. Always use a high quality pad

rated to operate at 2000 rpm.

Retighten the pad retainer as tight as possible.

Raise the back of the machine to lower the pad

housing by lifting as shown (6).

Dust Bag Installation (see ﬁ gure 7)

Install dust collector bag on top of control housing. The

dust collection system will not operate properly if the col-

lector bag is full or torn.

The pad pressure is set at the factory for optimal burnish-

ing with most pad and ﬁ nish combinations. If unique pad

or ﬁ nish conditions require pad pressure adjustments,

adjust by following the procedure below. NOTE: Pad

pressure adjustments should be performed by a qualiﬁ ed

service technician. (see ﬁ gure 8):

Turn the key switch off "O".

From underneath burnisher, loosen jam nut (A).

To decrease pad pressure, turn bolt (B) clockwise.

To increase pad pressure, turn bolt (B) counter-

clockwise.

Re-tighten jam nut (A).

Clarke

Operator's Manual (EN) - FUSION 20 / 20T

ENGLISH

Figure 7

Figure 8

FORM NO. 56091084 - 9 -