Clarke TFC 400 Manuel de l'opérateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Clarke TFC 400. Clarke TFC 400 13 pages.

Imprimer la page
Clarke TFC 400 Manuel de l'opérateur
INTRODUCTION
This manual will help you to get the most from your Clarke All Purpose Cleaner. Read it thoroughly
before operating the machine.
This product is intended for commercial use only.

PARTS AND SERVICE

Repairs, when required, should be performed by Clarke service personnel using original replacement
parts and accessories. Call Clarke for repair parts or service.
Please specify the Model and Serial number when calling about your machine.

NAME PLATE

The model and serial number of your machine are shown on the Name Plate on the machine.
This information is needed when ordering parts for the machine.
Use the space below to note the model and serial numbers of your machine.
MODEL NUMBER/NAME: __________________________________________________
SERIAL NUMBER: ________________________________________________________
NAME AND PHONE NUMBER OF YOUR DISTRIBUTOR: ______________________________
UNPACKING
When the machine arrives, carefully inspect the shipping carton and the machine for damage. If
damage is evident, save the shipping carton so that it can be inspected by the carrier.
Contact the Clarke customer service department immediately to fi le a freight damage claim.
DO NOT OPERATE THE MACHINE UNTIL YOU HAVE READ THIS SECTION
IMPROPER USE WILL VOID THE WARRANTY
•
Always use a defoamer when foaming occurs to prevent vacuum motor damage.
•
To keep fi ttings, pumps, and lines from damage during freezing conditions, use RV anti-freeze in
the pump or keep the machine inside heated areas.
•
Do not let the pump run dry.
•
All chemicals should be added through the feed system and NOT in the tank.
•
All extension cords must have a rating of at least 12/3 (12 gauge cord). Extension cords should
be no longer than 50 feet. Replace the plug immediately if the ground prong becomes damaged
or is broken off.
•
DO NOT use water heated to greater than 120 °F (50 °C).
3