Clarke CBS-12WB Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Clarke CBS-12WB. Clarke CBS-12WB 14 pages. 12" wood cutting bandsaw
Imprimer la page
16.
USE RECOMMENDED ACCESSORIES. Consult the owner's manual for
recommended accessories. The use of improper accessories may cause risk of injury
to persons.
17. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if
the cutting tool is unintentionally contacted.
18. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part
that is damaged should be carefully checked to determine that it will operate
properly and perform its intended function-check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other conditions
that may affect its operation. A guard or other part that is damaged should be
properly repaired or replaced.
19. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POW ER OFF. Don't
leave tool until it comes to a complete stop.
20. DIRECTION OF FEED. Feed work into a blade or cutter against the direction of
rotation of the blade or cutter only.
-14-
Special Safety Rules For Band Saws
1. Place the blade guard to within approximately 1/8" above the material being cut.
2. Always keep hands and fingers away from the saw blade, especially at the end of
a cut.
3. Use a push stick or piece of scrap wood to do the pushing and guiding when
sawing small pieces which require the fingers to be close to the saw.
4. Stop the machine before removing scrap pieces from the table.
5. Stop the machine if the material is to be backed out of an uncompleted cut.
6. Make all adjustments and set ups with the power off, such as tilting the table,
adjusting the saw blade guards and blade guides.
7. Adjust blade tension, upper and lower blade guides, backing bearing and blade
tracking correctly.
8. The cover housing must be in place and securely fastened when performing any
saw operations.
9. Securely lock all adjustable parts so they cannot loosen while sawing. This will
prevent distraction from the sawing operation.
10. When sawing curves, make relief cuts to allow removal of scrap material. This will
help prevent undue twisting or binding of the saw blade. The relief cuts are
made before starting the curved saw cut.
11. Hold material firmly and feed into the blade at a moderate speed.
12. Be sure to use proper blade size and type according to guide.
13. Do not saw stock that does not have a flat surface, unless a suitable support is
used.
14.
Keep open flame and high temperature tools such as soldering irons and blow
torches away from band saw.
15. Permanently mount your band saw before performing cutting operations.
-15-