Clarke CON14 Manuel d'utilisation et d'entretien - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CON14. Clarke CON14 17 pages. Abrasive cut-off saw
Imprimer la page
CHANGING AND CARE OF CUTTING DISCS
WARNING: BEFORE PERFORMING ANY MAINTENANCE, ENSURE THE PLUG
HAS BEEN REMOVED FROM THE MAINS SUPPLY.
CHANGING THE CUTTING DISC
Replacement 355 mm cutting discs part no: 6470800 (for metal) are available
from your Clarke dealer. Discs for cutting stone are part no: 6470760.
IMPORTANT: Ensure the disc is rated above the rated speed of the machine.
1. Disconnect the power
supply and with the
arm fully raised, move
the hinged guard fully
back.
• This will leave the
disc retaining bolt
exposed.
2. Turn the cutting disc by
hand until the spindle
engages the spindle
lock and holds it in
position.
3. Using the 8mm hex.
wrench, undo and
remove the abrasive disc retaining bolt, followed by the washer and
retaining disc. Finally, carefully remove the cutting disc.
4. Reassemble in reverse order, ensuring the cutting disc and retaining disc
are correctly mounted on the flats of the shaft with the retaining disc and
washer oriented as shown. Take care not to over tighten the centre bolt.
5. Always run the machine for 30 seconds and check for vibration when a
new disc is fitted.
HANDLING AND STORING CUTTING DISCS
Handle cutting discs carefully. Avoid dropping or bumping. Do not roll a disc
on its edge. Do not pile other items such as tools on top of cutting discs. Store
discs in racks or bins with dividers for different types of discs and ensure easy
access and less handling. Never store cutting discs near excessive heat or
cold, in contact with water, oil or moisture, nor in drawers with loose tools.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11