Clarke Woodworker CBS12WV Manuel d'utilisation et d'entretien - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke Woodworker CBS12WV. Clarke Woodworker CBS12WV 16 pages. 305mm (12”) portable bandsaw
Imprimer la page
1. Remove the table by fully unscrewing the two securing knobs, then slacken off all upper
and lower blade guides as described under 'Blade Guide Adjustments' on page 10.
2. Correctly tension the blade as described under 'Blade Tension' on page 8.
3. Remove the front cover in order to gain access to the blade and wheels.
WARNING! Disconnect the bandsaw from the mains supply before
removing the front cover.
4. Carefully turn the driving wheel (16, Fig. 2) by hand to check blade tracking, taking
care to keep fingers well clear of the blade, and not trapping them between the blade
and the wheel. The blade must run true, as close to the centre of the rim of each wheel
as possible.
5. Adjust the tracking by turning the Hex. socket head adjuster screw (26) a little at a
time....clockwise to move the blade inwards towards the motor side of the machine,
and anticlockwise to move it outwards. Turn the driving wheel by hand as you turn the
adjuster screw.
6. Check blade tension once again after completing the tracking adjustment and adjust
if necessary.
7. Replace the front cover (1), then adjust the Blade Guides as described in the following
paragraphs.
Fig, (4)
Blade Guard Locking Knob
23
Blade Tension Adjuster Screw
24
25
23
24
26
Blade Tension Locking Knob
25
Blade Tracking Adjust Screw
26
9