Clarke WOODWORKER CTS800B Instructions d'utilisation et d'entretien - Page 12
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke WOODWORKER CTS800B. Clarke WOODWORKER CTS800B 15 pages. 8” 200mm table saw
Imprimer la page
REPLACING THE SAW BLADE
1.
Remove the side cover by
unscrewing the five securing
screws.
2.
Place a steel bar or
screwdriver blade between
the table top and one of the
saw blade teeth, (at the point
arrowed in Fig.8), then undo
the saw blade securing nut -
normal right hand thread.
3.
Remove the outer flange
followed by the saw blade by
angling it outwards at the bottom so that it is clear of the motor shaft, and
carefully withdrawing it from below.
4.
Replace in reverse order ensuring the saw blade teeth face downwards at
the front of the table.
Hold the blade firmly whilst wearing a good industrial glove when tightening
the centre nut, taking care to avoid damaging your hand on the sharp
teeth.
RIVING KNIFE
The riving knife is an important component and must always be in place
and directly in line with the saw blade. It prevents the work from chattering
as it passes through the blade.
If necessary, remove the Table Insert, then slacken the two securing screws
and adjust accordingly, ensuring the clearance between the saw blade
and riving knife is 5mm maximum. Inspect at regular intervals to ensure
the gap is correctly maintained, and adjust as required.
It may also be necessary to remove the Riving Knife and bend back into
shape if it is not exactly in line with the saw blade.
12
Fig.8