Clarke 6926016 Instructions d'utilisation et d'entretien - Page 7
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 6926016. Clarke 6926016 13 pages. Halogen heaters
Imprimer la page
OPERATION
1. Place the heater where needed and lock the braked caster(s) to prevent it
from moving. When moving the heater use the handles.
2. Slacken the locking knobs and rotate the heater body to the required
angle. Tighten the knobs on each side to lock into place (SP models only).
3. Connect the mains cable to a suitable power supply.
4. Use the on/off switches to turn on either one, or both halogen tubes.
IMPORTANT: When using the SP model heaters, avoid tilting the heater
downwards even though the tilt safety switch may cut in to prevent
overheating of both the heater and the floor.
CLEANING & MAINTENANCE
If the heater has been in use always disconnect it from the power supply and
let it cool down for at least 15 minutes before performing any cleaning or
maintenance tasks.
PERIODICALLY
• If there is a build up of dirt, wipe thoroughly with a damp cloth. Take
care that no moisture enters the heater. Take care NOT to touch the
halogen tubes with your fingers.
• Check the mains cable for damage. Heat will cause the cable to
stiffen and crack. If this is found, have the cable replaced. Check
cable routing and ensure it is well away from the heat source.
• Ensure halogen tubes are free of dust (use compressed air to clean if
possible. (ALWAYS wear a dust mask if performing this operation)
• Refer to your Clarke dealer if internal maintenance is required.
• When storing the heater, let it cool down, then keep it in a dry,
ventilated place.
FITTING/ REPLACING QUARTZ HALOGEN TUBES
Before attempting to fit/replace halogen tubes, ensure the heater is switched
off and isolated from the electrical supply.
Never hold the halogen tubes with bare hands. Always handle using either a
soft clean glove or a piece of soft clean cloth wrapped around the tube.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7