Clarke 3110472 Instructions d'utilisation et d'entretien - Page 10

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 3110472. Clarke 3110472 17 pages. 6pc air scraper tool set

Imprimer la page

DISCONNECTING THE AIR SUPPLY

1. DO NOT disconnect the air supply hose until the compressor has been shut

down and the compressed air released.

2. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

3. Once the pressure has been released, disconnect the air supply hose from

the tool.

CARE AND MAINTENANCE

WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE

AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES.

DAILY

1. Before use, drain water from the air tank, air line and compressor.

2. Pour a few drops of CLARKE airline oil, into the air inlet. This should be

carried out regardless of whether or not an in-line mini oiler is used. If an in-

line mini oiler is not used, this procedure should be repeated after every

two to three hours of use.

CLEANING

1. Keep the body of the tool clean and free from debris.

2. Grit or gum deposits inside the tool

may also reduce its efficiency. This

condition can be corrected by

cleaning out the air strainer and

flushing out the tool with gum

solvent or oil, or failing this, the

motor may require dismantling.

This is better left to your CLARKE

dealer.

3. Periodically, check the air inlet

strainer for blockage and clean if

necessary.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]