Clarke Air CAT62 Instructions d'utilisation et d'entretien - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke Air CAT62. Clarke Air CAT62 17 pages. Punch & flange tool
Imprimer la page
• Moving to another work area.
• Passing the tool to another person.
• Never use the tool if it is defective or operating abnormally.
13. This tool should be serviced at regular intervals by qualified service
personnel.
14. Avoid damaging the tool for example by applying excessive force.
15. Always maintain the tool with care. Keep it clean for the best and safest
performance.
16. Do not force or misuse the tool. It will do a better and safer job at the rate
for which it was designed.
HAZARDS SPECIFIC TO CUTTING/PUNCHING TOOLS
1. Be careful around all moving parts and pinch points. Always keep your
fingers away from the point of cutting.
2. Ensure material is properly supported during cutting. Use supports for long
material. Hold the material securely to prevent it tilting during the cut. Use
clamps or vices to hold the work piece whenever possible.
3. Take care of sharp edges produced by the work.
4. Do not use damaged punches. When replacing cutting tool parts, make
sure they are correctly and securely fitted.
5. Anticipate the unexpected tool movement due to a binding punch.
Release the trigger immediately if this occurs.
TRANSPORTATION
1. Never carry an air tool by the air supply hose.
2. Never carry an air tool with your finger on the trigger.
STORAGE
1. When not in use, the tool must be disconnected from the air supply and
stored in a dry place out of the reach of children (preferably in a locked
cabinet).
2. Avoid storing in cold environments.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4