Clarke CAT33B Instructions d'utilisation et d'entretien - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CAT33B. Clarke CAT33B 4 pages.
Également pour Clarke CAT33B : Instructions d'utilisation et d'entretien (13 pages)
Imprimer la page
MAINTENANCE
Daily
1.
Before use, drain water from air tank, air line and compressor.
2.
If no line Lubricator is used, ensure that oil is applied to the tool (see below).
Weekly
Clean the air inlet filter.
Monthly
Run a few drops of oil through the tool. It may be entered into the tool air inlet (B), ensuring the strainer
is clear, or into the hose at the nearest connection to the air supply. Then run the tool. A rust inhibitive
oil, available from auto supply stores etc., is acceptable.
Be aware that factors other than the tool may effect its operation and efficiency, such as reduced
compressor output, excessive drain on the airline, moisture or restrictions in the line, or the use of
connectors of improper size or poor condition which will reduce air supply. Grit or gum deposits in the
tool may also reduce efficiency. This condition can be corrected by cleaning the air strainer and
flushing out the tool with gum solvent oil, or failing this, the tool should be dis-assembled, thoroughly
cleaned, dried and re-assembled.
Keep the tool clean at all times,
ACCESSORIES
A wide range of Airline accessories is available, including Filter/Regulators, Lubricators, High Pressure
Hoses from 5 to 100 Metres, etc. Contact your CLARKE dealer for further information, or CLARKE
International Spare Parts Department on 020 8988 7400
SPECIFICATIONS
Model No. ................................................... CAT 33B
Part No. ....................................................... 3110433
Air Inlet ........................................................ 1/4" BSP
Min. Hose Size (ID) ...................................... 5/16" (8mm)
Net Weight .................................................. 1.5 kg