Clarke CHT697 Vue d'ensemble

Parcourez en ligne ou téléchargez le pdf Vue d'ensemble pour {nom_de_la_catégorie} Clarke CHT697. Clarke CHT697 2 pages. Bearing race and seal driver set

Imprimer la page

BEARING RACE AND SEAL DRIVER SET

SAFETY

WARNING: THE WARNINGS, CAUTIONS AND INSTRUCTIONS DISCUSSED IN THIS SHEET CANNOT COVER

ALL POSSIBLE CONDITIONS AND SITUATIONS THAT MAY OCCUR. IT MUST BE UNDERSTOOD THAT

COMMON SENSE AND CAUTION ARE FACTORS WHICH MUST BE APPLIED BY THE OPERATOR.

WARNING: ALWAYS WEAR APPROVED EYE PROTECTION WHEN USING THE DRIVER. FAILURE TO DO SO

MAY RESULT IN SERIOUS INJURY. NORMAL SPECTACLES ARE NOT ADEQUATE PROTECTION.

Familiarise yourself with the specific applications and limitations

of the driver, as well as any potential hazards.

2. Strike the driver squarely on the head - DO NOT hit the tool off

centre, or at an angle.

3. If unsure of the applications or limitations of the driver, contact

your supplier.

4. Ensure that the driver is the correct tool for the task. DO NOT use

the driver for any purpose other than that for which it is designed.

5. Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous

and will invalidate the warranty.

6. DO NOT use the driver if it is bent, chipped, has a mushroom

head, or is otherwise damaged as this may cause failure and/or

personal injury.

7. Ensure that the workpiece is stable and that there is adequate

lighting.

8. Maintain your correct balance and footing. Ensure the floor is not

slippery and wear non-slip shoes.

9. Use the correct size and type of hammer for the task. The

recommended diameter of the hammer face is 10 mm larger

than tool head. Check that the hammer handle is in good

condition and is secure in the hammer head.

For seal installation a soft-faced hammer should be adequate and will be less likely to damage the

NOTE:

tool.

10. DO NOT strike the side of the driver body.

11. Make sure that the face of the hammer and the head of the tool

are clean and free from grease, oil, etc.

12. Position the tool so that it is struck away from your body.

13. DO NOT use the driver when you are tired or under the influence

of alcohol, drugs or intoxicating medication.

14. Keep children and unauthorised persons away from the working

area.

15. When not in use, pack into the case, and store in a safe, dry, childproof location.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Model Number: CHT697

Part Number: 1801697