Clarke IT1500 Manuel d'utilisation et d'entretien - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke IT1500. Clarke IT1500 17 pages. Induction heater
Imprimer la page
Remove and repair of dents:
1. Follow the instructions for preparation of
operation and set up on page 8.
2. Bend the coil in the way that looks like the
drawing on the right and relevent to the size of the dent.
3. Press the heating switch to start the heater.
4. Place the coil 12 to 25 mm
above a dent and move the
coil in small circular motions
inward around the outside of
the crown of the dent. If the
dent shrinks, pull the heating
coil back quickly and cool
the dent with a damp cloth.
If the dent sucks in, then you
are heating the crown, or
you are not far enough from the outside of the crown of the dent.
5. Repeat the procedure until the dent is removed to your satisfaction.
NOTE: Should smoke appear from the dent, immediately remove the
coil. At this point, the paint will start to bubble. Also pay attention
that white and light colours tend to become yellowish earlier
than dark colours.
NOTE: In case the dent does not seem to shrink, it may be caused by a
crease in the metal or the metal has been distorted too much.
11