Clarke KIT1100 Manuel d'utilisation et d'entretien - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke KIT1100. Clarke KIT1100 17 pages. Air tool kit
Imprimer la page
SPRAY GUN
1. Never spray paint close to any source of heat or flame.
2. Always ensure the spraying area has adequate fresh air ventilation.
3. Always make sure there is adequate ventilation. Do not spray in confined
or enclosed areas.
4. Always wear a suitable approved breathing mask when spraying, to
protect against inhalation of paint spray or fumes. An air feed mask may
be required when spraying toxic types of paint. If in doubt, check with the
paint manufacturer.
5. Always check the manufacturer's data sheets on the paint products being
sprayed for any particular hazards, and follow the manufacturer's
instructions. Take particular care if spraying isocyanate paints.
6. Always disconnect the spray gun from the air supply when it is not in use,
and before any disassembly.
7. Always keep the spray nozzle in place when spraying.
8. Always thoroughly clean the spray gun after use. See 'Maintenance' on
page 13.
9. In the case of injury, seek expert medical advice immediately. Never
smoke while spraying or preparing paints, or spray near a naked flame,
heat source and electric sparks. Many paints are flammable.
10. Never exceed the maximum input air pressure of 50psi (3.5 bar).
NOTE: Products used in this spray gun may be covered by COSHH
Regulations.
11. When replacing parts, only use those supplied by Clarke International as
stated in the parts list on page 14.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4