Claro CFCLSU2LWH Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Claro CFCLSU2LWH. Claro CFCLSU2LWH 15 pages.

Imprimer la page

Ceiling fan instruction booklet

Thank you for purchasing your Claro Summer DC Ceiling Fan. Please read all instructions

carefully before assembly and use.

IMPORTANT SAFEGUARDS

Read all instructions carefully, even if you feel you are quite familiar with this type of appliance. When

using electrical appliances, in order to reduce the risk of fire, electric shock, and/or injury, these

basic safety precautions should always be followed:

1. All wiring must be done by a licenced electrician as on-site warranty may be voided if proof

cannot be provided. This ceiling fan MUST be installed by a Qualified Electrical Contractor in

accordance with the local regulations, and all local, state and national electrical codes. Any

alterations or additions to building wiring must be completed by a licensed electrical contractor, or

person authorised by legislation to work on the fixed wiring of any electrical installation.

2. The fan must be connected to a 240V AC 50Hz power supply.

3. All electrical work must only be undertaken after disconnection of the power by removing fuses

or turning off the circuit breaker, to ensure all pole isolation of the electrical supply.

4. The fan must be earthed.

5. The fan must be installed so that the blades are at least 2.1 metres above the floor.

6. The ceiling fan weight is max. 8 kg. The structure that the ceiling fan is mounted to must be

capable of supporting a weight of at least 45kg. The fixing must be able to support the moving

weight of the fan and must not twist or work loose.

7. Make sure that the installation site will not allow the rotating fan blades to come into contact with

any object and that there is enough space from the blade tip to the wall or ceiling. Please note that

insufficient clearance distances might cause wobbling and the bigger this clearance is the better the

airflow from your fan will be.

8. DO NOT install CFCLSU2WH and CFCLSU2LWH outdoors. Installing the fan in a position where it

could be exposed to water, moisture or external elements is dangerous.

9. CFCLSU2WHABS and CFCLSU2LWHABS can be installed in a position where it is covered or

enclosed al fresco areas and there is a minimum clearance of 1.50 m from the blade tip to all edges

of the roof or positions where could be exposed to water, moisture or other dangerous external

elements.

10. DO NOT connect the fan motor to a dimmer switch. This may give an unsatisfactory

performance (motor hum) and cause damage to the motor and/or controller. Use ONLY the

provided remote control.

11. This appliance is not intended for use by young children or infirm persons without supervision.

12. Young children should be supervised to ensure that they DO NOT play with the appliance.

13. It is NOT recommended that ceiling fans and gas appliances be operated in the same room at

the same time.

14. The fan must be turned off and stopped completely before reversing the fan direction. This will

prevent any damage to the motor of the fan or controller.

15. Do not insert anything into the fan blades whilst they are spinning. This will damage the blades

and upset the balance of the fan causing the unit to wobble.

16. After the fan is completely installed make sure that all base and fan blade fixings are secured and

tightened to prevent any problems.

17. Because of the fan's natural movement, some connections may loosen. Check the support

connections, brackets and blade attachments twice a year to make sure they remain secured. If any

are loose, tighten.

18. If unusual oscillating movement is observed, immediately stop using the ceiling fan and contact

the manufacturer, its service agent or suitably qualified persons.

19. The replacement of parts of the safety suspension system device shall be performed by the